Hand-Held Presentation Scanning - Motorola DS4800 Series Product Reference Manual

2 - 6 DS4800 Series Corded Digital Imager Product Reference Guide

Hand-Held Presentation Scanning

This mode is disabled by default. Initially in this mode:
•
The aiming dot and illumination are off.
•
The white trigger LED is off.
•
The green indicator LED continuously pulses.
When lifted off the counter or removed from the presentation intellistand:
•
The DS4800 detects motion and turns illumination on.
•
Optionally, the aiming dot turns on if enabled via
•
The green indicator LED turns off.
Aim the imager at a bar code to activate decode processing.
Hand-Held Presentation Scanning
Figure 2-4
When a bar code is decoded:
•
A tone sounds (by default). To change the tone, see
To disable the tone, see
•
The green indicator LED turns on momentarily (by default), then returns to idle state and pulses. To
disable this, see
•
If enabled, the imager provides haptic feedback. See
page 4-13.
Beep After Good Decode on page
LED on Good Decode on page
Hands-Free Decode Aiming Pattern on page
Scan Tone on page 4-10.
4-7.
4-12.
Haptic Feedback (Vibrate) on Good Decode on
4-19.