Idc Delay Time; Idc Zoom Limit - Motorola DS4800 Series Product Reference Manual

IDC Delay Time

Parameter Name: DocCap_DELAY
Parameter # 830
Set the delay for capturing a document after a trigger pull. Decoding a bar code aborts this delay. This
parameter only applies in Free-Form mode.
Scan the bar code below, followed by three bar codes from
000 to 200 decimal in units of 10 msec. The default is 000.
IDC Delay Time

IDC Zoom Limit

Parameter Name: Sig_MIN_PERCENT
Parameter # 651
Set the minimal "zoom" percentage value of a form for it to be considered for capture. This controls the quality
of the captured form. The IDC firmware rejects capturing a form unless the width is at least the
percentage of the IDC Width
the form must be at least 300 pixels wide before it is captured (each unit module is scaled to two pixels).
Set this to zero (the default) to disable all checking. This parameter only applies in Anchored mode.
Scan the bar code below, followed by three bar codes from
000 to 100 percent. The default is 000.
parameter. For example, if you set this parameter to 100 and
Intelligent Document Capture 7 - 15
Appendix G, Numeric Bar Codes
Appendix G, Numeric Bar Codes
IDC Zoom Limit
in the range of
IDC Zoom Limit
IDC Width to 150,
in the range of