12
SERVICE WORK ON THE CHASSIS
12.13
Installing the lower triple clamp
Main work
–
Remove screw
dlebar and hang it to one side.
Info
Protect the components against damage by covering them.
Do not bend the cables and lines.
602734-10
–
Remove O-ring
–
Take off the lower triple clamp with the steering stem.
–
Remove the upper steering head bearing.
602735-10
(EXC, XC‑W)
Main work
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
–
Check whether the top steering head seal
–
Mount protective ring
500151-10
–
Position the upper triple clamp with the steering.
–
Position the clutch line and wiring harness.
–
Mount screw
B02151-10
–
Position the fork legs.
Info
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
Position bleeder screws
B02152-10
. Remove screw
. Pull off the upper triple clamp with the han-
. Remove protective ring
p. 137)
.
but do not tighten yet.
toward the front.
.
is correctly positioned.
55