12
SERVICE WORK ON THE CHASSIS
12.10
Installing the fork protector
12.11
Removing the lower triple clamp
12.12
Removing the lower triple clamp
Main work
–
Position the fork protection on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the fork protection on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis
101327-10
Finishing work
–
Install the fork legs.
–
Install the front wheel.
–
Refit the headlight mask with the headlight. (
–
Check the headlight setting. (
(EXC, XC‑W)
Preparatory work
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the headlight mask with the headlight. (
–
Remove the fork legs.
–
Remove the front fender. (
–
Remove the handlebar cushion.
Main work
–
Remove screw
dlebar and hang it to one side.
Info
Protect the components against damage by covering them.
Do not bend the cables and lines.
B02149-10
–
Remove O-ring
–
Take off the lower triple clamp with the steering stem.
–
Remove the upper steering head bearing.
B02150-10
(Six Days, EXC Factory Edition)
Preparatory work
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the headlight mask with the headlight. (
–
Remove the fork legs.
–
Remove the front fender. (
–
Remove the handlebar cushion.
(
p. 52)
(
p. 86)
p. 96)
(
p. 86)
(
p. 52)
p. 60)
. Loosen screw
. Pull off the upper triple clamp with the han-
. Remove protective ring
(
p. 86)
(
p. 52)
p. 60)
M6
10 Nm (7.4 lbf ft)
M6
10 Nm (7.4 lbf ft)
p. 94)
p. 50)
p. 94)
.
p. 50)
p. 94)
54
.