15
ELECTRICAL SYSTEM
15.1
Removing the battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep sparks and open flames away from the battery. Only charge in well-ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
15.2
Installing the battery
(All 200/250/300 models)
Preparatory work
–
Switch off all power consumers and the engine.
–
Remove the seat. (
Main work
–
Disconnect negative cable
–
Pull back positive terminal cover
battery.
–
Detach rubber band
–
Lift the battery out.
B02135-10
(All 200/250/300 models)
Main work
–
Insert the battery into the battery compartment with the terminals facing to the
front.
(All 200/250/300 EU/AU/US models)
Battery (YTX4L-BS) (
(300 EXC BR)
Battery (YTX5L-BS) (
–
Attach rubber band
–
Position the positive cable
Guideline
Screw, battery terminal
Info
Contact disks
ets
–
Slide positive terminal cover
B02136-10
–
Position the negative cable
Guideline
Screw, battery terminal
Finishing work
–
Mount the seat. (
p. 62)
from the battery.
and disconnect the positive cable from the
at the bottom.
p. 121)
p. 121)
.
and mount and tighten the screw.
must be mounted between screws
with the claws facing down.
over the positive terminal.
and mount and tighten the screw.
p. 62)
M5
2.5 Nm
(1.84 lbf ft)
and cable sock-
M5
2.5 Nm
(1.84 lbf ft)
91