12
SERVICE WORK ON THE CHASSIS
12.22
Removing the seat
12.23
Mounting the seat
Guideline
Screw, bottom shock
absorber
(All 250/300 models)
–
Push splash protector
and tighten screw
Guideline
Screw, top shock
absorber
–
Mount and tighten screw
Guideline
B02158-11
Screw, bottom shock
absorber
Finishing work
–
Remove the motorcycle from the lift stand. (
–
Remove screw
above.
B00817-10
–
Hook in the front of the seat at the collar bushing of the fuel tank, lower at the rear
and simultaneously push forward.
–
Make sure that the seat is correctly locked in.
602715-01
M12
Info
The heim joint for the shock absorber at the swing arm is Teflon
coated. It must not be lubricated with grease or with other lubricants.
Lubricants dissolve the Teflon coating, thereby drastically reducing the
service life.
to the side and position the shock absorber. Mount
.
M12
.
M12
Info
The heim joint for the shock absorber at the swing arm is Teflon
coated. It must not be lubricated with grease or with other lubricants.
Lubricants dissolve the Teflon coating, thereby drastically reducing the
service life.
. Lift up the seat at the rear, pull it back and then remove from
80 Nm
Loctite
®
2701™
(59 lbf ft)
80 Nm
Loctite
®
2701™
(59 lbf ft)
80 Nm
Loctite
®
2701™
(59 lbf ft)
p. 50)
62