12
SERVICE WORK ON THE CHASSIS
12.19
Installing the front fender
12.20
Removing the shock absorber
12.21
Installing the shock absorber
Main work
–
Position the front fender. Mount and tighten screws
Guideline
Remaining screws, chassis
B02156-10
–
Mount and tighten screws
Guideline
Remaining screws, chassis
B02155-11
Finishing work
–
Refit the headlight mask with the headlight. (
–
Check the headlight setting. (
Preparatory work
–
Raise the motorcycle with the lift stand. (
Main work
(All 125/200 models)
–
Remove screw
ble without blocking the rear wheel. Fix the rear wheel in this position.
–
Remove screw
absorber.
B02157-10
(All 250/300 models)
–
Remove screw
ble without blocking the rear wheel. Fix the rear wheel in this position.
–
Remove screw
absorber.
B02158-10
Main work
(All 125/200 models)
–
Push splash protector
and tighten screw
Guideline
Screw, top shock
absorber
–
Mount and tighten screw
B02157-11
M6
.
M6
p. 96)
p. 50)
and lower the rear wheel with the swing arm as far as possi-
, push splash protector
and lower the rear wheel with the swing arm as far as possi-
, push splash protector
to the side and position the shock absorber. Mount
.
M12
.
.
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
p. 94)
to the side, and remove the shock
to the side, and remove the shock
Loctite
®
2701™
80 Nm
(59 lbf ft)
61