Installing The Lower Triple Clamp (Exc Eu, Exc Aus, All Xc-W Models) - KTM 2013 450 EXC SIX DAYS EU Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.13 Installing the lower triple clamp
3 0 0 3
2 0 0 2
1 0 0 1
(EXC EU, EXC AUS, all XC‑W models)
x
Main work
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
–
Check whether the top steering head seal
–
Slide on protective ring
101330-10
–
Position the upper triple clamp with the steering.
–
Mount screw
–
Position the clutch line, wiring harness, and voltage regulator. Mount and tighten
screws .
5
Guideline
Remaining screws, chassis
101427-10
–
Position the fork legs.
Info
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
Position bleeder screws
101332-10
–
Tighten screws
Guideline
Screw, bottom triple clamp
101333-10
–
Tighten screw
Guideline
Screw, top steering head
101428-10
p. 116)
and O-ring .
2 3
but do not tighten yet.
4
toward the front.
6
.
7
.
4
is correctly positioned.
1
M6 10 Nm (7.4 lbf ft)
M8 15 Nm
(11.1 lbf ft)
M20x1.5 12 Nm (8.9 lbf ft)
49