12
SERVICE WORK ON THE CHASSIS
12.7
Removing the fork legs
12.8
Installing the fork legs
Preparatory work
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the headlight mask with the headlight. (
Main work
–
Remove screws
–
Remove cable binder
–
Remove screws
–
Hang the brake caliper and the brake line loosely to the side.
B00798-10
(EXC, XC‑W)
–
Loosen screws
–
Loosen screws
B02146-10
(Six Days, EXC Factory Edition)
–
Loosen screws
–
Loosen screws
B02147-10
Main work
(EXC, XC‑W)
–
Position the fork legs.
B02148-10
(Six Days)
–
Position the fork legs.
602754-10
(
p. 86)
and take off the clamp.
.
and take off the brake caliper.
. Remove the fork leg on the left.
. Remove the fork leg on the right.
. Remove the fork leg on the left.
. Remove the fork leg on the right.
Info
Grooves are milled into the side of the upper end of the fork legs. The
second milled groove (from the top) must be flush with the top edge of
the upper triple clamp.
Position bleeder screws
Info
The rebound damping is located in the right fork leg REB (red adjusting
screw). The compression damping is located in the left fork leg COMP
(white adjusting screw).
Grooves are milled into the side of the upper end of the fork legs. The
second milled groove (from the top) must be flush with the top edge of
the upper triple clamp.
Position bleeder screws
p. 50)
p. 94)
toward the front.
toward the front.
52