11
TUNING THE CHASSIS
11.16
Adjusting the handlebar position
Warning
Danger of accidents Handlebar breakage.
–
If the handlebar is bent or straightened it will cause material fatigue, and the handlebar can break. Always replace handle-
bar.
–
Remove screws
to one side.
Info
Protect the components against damage by covering them.
Do not bend the cables and lines.
–
Remove screws
–
Place the handlebar support in the required position. Mount and tighten
screws
101488-10
Guideline
Screw, handlebar support
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount screws
Guideline
Screw, handlebar clamp
Info
Make sure the gap widths are even.
. Remove the handlebar clamp. Remove the handlebar and lay it
. Remove the handlebar support.
.
M10
Loctite
40 Nm
(29.5 lbf ft)
and tighten evenly.
M8
20 Nm
(14.8 lbf ft)
49
®
243™