6
FORK, TRIPLE CLAMP
6.12.7
Assembling the cartridge
Info
The steps are identical for both fork legs.
–
Mount shim stack
Info
Mount the smaller shims below.
–
Mount pistons
Info
The side with the largest inside diameter
200705-10
–
Grease the piston O-ring.
Fork oil (SAE 4) (48601166S1) (
–
Mount washer
–
Mount spring
–
Mount and tighten nut
Guideline
Compression damping fitting nut
Info
The washer
200706-10
–
Secure the nut by locking.
–
Extract the compression damping fitting.
–
Clamp in the piston rod.
Clamping stand (T14016S) (
–
Mount valve
–
Grease the O-ring.
Lubricant (T158) (
–
Mount spring
200715-10
–
Grease tap rebound
Lubricant (T158) (
–
Mount and tighten the tap rebound.
Guideline
Tap rebound
–
Position spring
200718-10
–
Mount shim stack
Info
Mount the smaller shims below.
–
Press the shim stack downward against the spring force.
Info
The shim stack must be pressed downward over the collar.
200719-10
–
Mount piston
.
with O-ring
.
p. 339)
.
with the tighter coil facing downward.
.
must have freedom of movement relative to the spring force.
p. 352)
of the rebound damping, with the spring and O-ring.
p. 340)
.
O-ring.
p. 340)
M9x1
.
.
with the piston ring.
faces upward.
M6x0.5
3 Nm (2.2 lbf ft)
18 Nm
Loctite
(13.3 lbf ft)
26
®
2701™