KTM 350 EXC-F EU Repair Manual page 49

6 FORK, TRIPLE CLAMP
–
Lubricate and mount dust boot
Lubricant (T511) (
Info
Always change the dust boot, seal ring, lock ring and support ring.
Mount the sealing lip with the spring expander facing downward.
–
Slide on lock ring
–
Lubricate and slide on seal ring
Lubricant (T511) (
Info
Mount with the sealing lip facing down and the open side facing up.
–
Slide on support ring
–
Remove the special tool.
–
Grind the edges of the sliding bushings with sandpaper grit 600, clean the bush-
ings and lubricate them.
Fork oil (SAE 4) (48601166S1) (
201715-10
–
Slide on the lower sliding bushing
–
Mount the upper sliding bushing
Info
Do not use a tool; pull the ends apart slightly by hand.
201716-10
–
Warm the outer tube in area
Guideline
50 °C (122 °F)
–
Slide the outer tube onto the inner tube.
–
Hold the lower sliding bushing with the longer section of the special tool.
Mounting tool (T14040S) (
–
Push the sliding bushing all the way into the outer tube.
201717-10
–
Position the support ring.
–
Hold the seal ring with the shorter section of the special tool.
Mounting tool (T14040S) (
–
Push the seal ring and support ring all the way into the outer tube.
201718-10

.
p. 340)
 .

.
p. 340)

.
p. 339)

.

.

of the lower sliding bushing.
p. 353)
p. 353)
47