Handlebar, Controls; Handlebar Position; Adjusting Handlebar Position; Adjusting The Basic Position Of The Clutch Lever - KTM 350 EXC-F EU Repair Manual

7

HANDLEBAR, CONTROLS

7.1

Handlebar position

7.2

Adjusting handlebar position

Warning
Danger of accidents Handlebar breakage.
–
If the handlebar is bent or straightened it will cause material fatigue, and the handlebar can break. Always replace handle-
bar.
7.3

Adjusting the basic position of the clutch lever

On the upper triple clamp, there are two holes at a distance of
Hole distance
The holes on the handlebar supports are placed at a distance of
Hole distance
The handlebar supports can be mounted in four different positions.
101487-10
–
Remove screws
it to one side.
Info
Protect the motorcycle and its attachments from damage by covering them.
Do not bend the cables and lines.
–
Remove screws
–
Place the handlebar supports in the required position. Mount and tighten
screws 
101488-10
Guideline
Screw, handlebar holder
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount and tighten screws
Guideline
Screw, handlebar clamp
Info
Make sure the gap width is even.
–
Adjust the basic setting of the clutch lever to your hand size by turning adjusting

screw
Info
Turn the adjusting screw clockwise to increase the distance between the
clutch lever and the handlebar.
Turn the adjusting screw counterclockwise to decrease the distance between
the clutch lever and the handlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not apply any force.
M00122-10
Do not make any adjustments while riding!
15 mm (0.59 in)

3.5 mm (0.138 in)

 . Take off the handlebar clamps. Remove the handlebar and lay

. Take off the handlebar supports.
.
M10
.

to each other.

from the center.
40 Nm Loctite
(29.5 lbf ft)

evenly.
M8 20 Nm
(14.8 lbf ft)
54
® 243™