9
SHOCK ABSORBER, SWINGARM
Main work
–
Slide the spring and piston onto compression adjuster
–
Grease the O-ring.
Lubricant (T158) (
–
Grease the threads.
Lubricant (T159) (
–
Mount and tighten the compression adjuster.
200774-10
Guideline
Compression adjuster
–
Install adjusting ring
Info
The adjusting ring cannot be mounted after the piston rod has been assem-
bled!
201621-11
–
Mount screw
201619-11
–
Grease the O-ring of the seal ring retainer.
Lubricant (T158) (
–
Fill the damper cartridge approximately half way.
Shock absorber fluid (SAE 2.5) (50180751S1) (
–
Carefully mount the piston rod.
201620-10
–
Mount seal ring retainer
–
Mount lock ring
Info
Do not scratch the inner surface.
–
Pull out the piston rod in order that the seal ring retainer fits closely against the
lock ring.
201618-11
–
Mount locking cap
–
Bleed and fill the damper. (
–
Fill the damper with nitrogen. (
201622-10
p. 340)
p. 340)
with an intermediate washer.
but do not tighten yet.
p. 340)
and slide it under the ring groove.
.
of the damper cartridge.
p. 75)
p. 77)
.
M31x1
50 Nm
(36.9 lbf ft)
p. 339)
73