Configuring Sharelink 200 Settings - Extron electronics ShareLink 200 User Manual

Configuring ShareLink 200 Settings

To access the ShareLink 200 admin (configuration) pages:
1.
2.
After login, the following admin pages appear:
Figure 32.
•
•
•
•
•
•
•
Click the Configure button on the top right hand corner of the landing page
28, 1, page 27). The login page opens.
Enter the password and click Login. The default password is "configure".
NOTE: This password can be changed (see
ShareLink 200 Admin Pages
System Status — The System Status page appears by default. This page displays
basic information about the ShareLink 200 model, network status, connection status,
and date and time.
Device Setup — Use this page to adjust the ShareLink 200 output resolution, login
code, date and time, and to reboot settings (see
Network Setup — Use this page to adjust network settings for the ShareLink 200,
such as host name, domain name, IP settings, DHCP settings, and GateKeeper (see
Network Setup on page 33).
WiFi Setup — Use this page to adjust Wi-Fi settings, including wireless LAN, AP and
Client mode, access point, and Wi-Fi client settings (see
SNMP Setup — Use this page to enable or disable SNMP service, and to configure
settings for managing the ShareLink 200 via SNMP (see
OSD Setup — Use this page to upload a custom standby image or reset the stanby
image to default, and to choose which device information to display on the standby
screen (see OSD Setup on page 38).
WebShare Setup — Use this page to set the auto refresh interval and the Access
Password Code for WebShare (see
Change Passwords
Device Setup
WiFi Setup
SNMP Setup
WebShare Setup on page 39).
ShareLink 200 • Using the Embedded Web Pages
(figure
on page 40).
on the page 32).
on page 34).
on page 37).
30