Table of Contents
Advertisement
Henny Penny
7-3. USAGE REVIEW
OPERATION
7-4. USAGE REVIEW/
RESET OPERATION
7-5. PROGRAMMING IN
GENERAL
600
1. Push PROGRAM button (G) 2 seconds, until "USAGE"
LED (P) flashes. First product is selected.
2. Left display shows usage type for selected product. Type is
"daily" or "total". Right display shows usage for selected
product. Push PROGRAM button to change between daily
and total displays.
3. If timer alarms occur during usage review, push TIMER button
(B) to acknowledge alarm. Usage review resumes.
4. Push change buttons (C) to select products. When all pro-
duct LEDs (D) turn on, total usage of all products is shown.
5. Push and hold PROGRAM button to exit usage review.
1. While in usage review, press and hold INTERVAL
SELECT button (S) for 5 seconds; the buzzer beeps three
times and the "USAGE RESET" LED will flash.
2. Select product and product type as described above. Push
RESET button (R) to clear displayed usage count.
3. Push and hold PROGRAM button to exit usage review.
1. The two programming levels are: regular program mode and
special program mode. To enter regular program mode, turn
the key switch to the "Program" position, except during a cook
cycle. To enter special program mode, hold the PROGRAM
button (G) for 10 seconds, while in regular program mode.
2. The left display always describes the item being programmed,
and the right display always shows the item setting. Push the
change buttons, (L & R)-4 product controls; (J)-10 product
controls, to change the item shown in the right display. Push
and hold the change button to change the item more quickly.
3. If timer alarms occur while programming, push the TIMER
button (B) to acknowledge the alarm and resume programming.
4. Turn the key switch back to the "Cook" position when done
programming.
Model 520
7-3
Advertisement
Table of Contents
