Henny Penny 520 Service Manual page 38

Place power switch in the OFF position, shut off power
at the fuse or breaker box. Failure to do so could result
in electrical shock.
1. Follow steps 1,
2
and 3 in Removal of Control Panel.
2. Remove the two screws securing motor to timer.
3. Cut wires on old motor. (Note: Mark wires before cutting.)
4. Install new motor and splice cut wires.
Place power switch in the OFF position, shut off power
at the fuse or breaker box. Failure to do so could result
in electrical shock.
1. Follow steps 1, 2 and 3 in Removal of Control Panel.
2. Unplug wires from old power switch. (Note:
ark wires
before removing.)
3. Depress retainers on rear of switch and push switch out
towards front of control panel.
. Install new power switch.