Table of Contents
Advertisement
Henny Penny
7-1. INTRODUCTION
7-2. CONTROL PANEL LAYOUT
A. Turns on when shortening temperature is in ready range.
B. Push to start timer. Push and hold to abort running timer. Push at end of cook cycle to stop alarm.
C. Push to select product, Idle or Clean modes.
D. Shows the selected item.
E. Slide menu card in and out from inside of panel.
F. One of these flashes during program mode to show which item is being programmed.
G. Push and hold to display usage. Push to toggle between Daily and Total usage. Push and hold to
exit usage mode.
H. Flashes during usage reset.
I. Shows intervals in Program mode.
J. Push to scroll parameters in program mode.
K. Shows temperature in standby mode, "CLn", in Clean mode, and time during a cook cycle.
L. Push to show temperature in right display, and acts as an increase switch in Program mode.
M. Turns on when heat is on.
N. Flashes during melt.
O. Push and hold for 5 seconds to bypass melt cycle.
P. Flashes during review usage.
Q. Turns on with pressure solenoid.
R. Push to reset usage, and acts as a decrease button in Program mode.
S. Push to select interval in Program mode.
T. Shows temperature when temperature button is depressed during a cook cycle, and shows "CLn",
in Clean mode.
600
SECTION 7. ELECTRONIC CONTROLS
The Henny Penny Pressure Fryer Model 520 can come equipped
with electronic controls. These controls allow for a consistent
product, and displays temperature and timing cycles.
Figure 7-1
Four Product Control
Model 520
7-1
Advertisement
Table of Contents
