Table of Contents
Advertisement
Henny Penny
7-2. CONTROL PANEL LAYOUT
(Continued)
K
A
B
C
D
A. Turns on when shortening temperature is in ready range.
B. Push to start timer. Push and hold to abort running timer. Push at end of cook cycle to stop alarm.
C. Push to select product, or the Clean mode.
D. Shows the selected product. (left and right)
E. Slide menu cards in and out from inside of panel.
F. Turns on when the Clean mode has been selected.
G. Push and hold to display usage. Push to toggle between Daily and Total usage. Push and hold to
exit usage mode. Push to scroll parameters in program mode.
H. Flashes during usage reset.
I. Shows intervals in program mode.
J. Sets parameter increments in Program mode.
K. Shows "CLn" during Clean mode, and shows time remaining in cook cycle.
L. Turns on when heat is on.
M. Push to display temperature in right display.
N. Flashes during melt.
O. Push and hold for 5 seconds to bypass melt cycle.
P. Flashes during review usage.
Q. Turns on with pressure solenoid.
R. Push to reset usage.
S. Push to select interval (in program mode), or to enter Reset Usage.
T. Shows temperature when temperature button is depressed during a cook cycle, and shows "CLn",
in Clean mode
7-2
P
G
M
E
H
I
Figure 7-2
Ten Product Control
L
CLEAN
S
F
Model 520
T
Q
R
J
O
N
600
Advertisement
Table of Contents
