2-10] Extension Cid Settings - Panasonic KX-TDA100 Programming Manual

4.18 [2-10] Extension CID Settings

Various settings for extension Caller ID can be programmed.
Extension Caller ID Resource-1, 2 (KX-TDA30 only)
Specifies a group of 4 SLT ports that can transfer Caller ID information to connected SLTs.
When the port to which an extension is connected has this feature activated, there will be a short delay before
the extension rings for incoming calls.
Value Range
Disable: No port
Slot 01:DHLC4: Initially installed 4 Super Hybrid ports
Slot nn:SLC4: Ports 1 to 4 of the SLC4 card (nn=slot number)
Slot nn:SLC8 1-4: Ports 1 to 4 of the SLC8 card (nn=slot number)
Slot nn:SLC8 5-8: Ports 5 to 8 of the SLC8 card (nn=slot number)
Maintenance Console Location
4.18 [2-10] Extension CID Settings
Programming Manual References
6.1 [4-1-1] Wired Extension—Extension Settings—Option 8—
Feature Guide References
1.18.1 Caller ID
Extension Caller ID Modulation Type
Specifies the modulation frequency to be used when sending Caller ID information to an SLT.
Value Range
V.23(ETSI), Bell202(Bellcore)
Maintenance Console Location
4.18 [2-10] Extension CID Settings
Programming Manual References
None
Feature Guide References
1.18.1 Caller ID
Channel Seizure Signal Bits
Specifies the number of seizure bits to send when sending Caller ID information to an SLT.
4.18 [2-10] Extension CID Settings
Extension Caller ID Sending
PC Programming Manual 477