Setup
Replacing the Battery
Before replacing the Battery, read
annual replacement of rechargeable battery packs to ensure maximum performance.
To change the battery of your reader, complete the following instructions.
1. With a screwdriver, unscrew the battery cover screw.
2. Unscrew and remove the three screws securing the battery holder, and unplug the white
3. Carefully lift out the gold contacts circuit, and remove the battery holder while letting the
34
connector.
Connector
white connector pass through the hole in the battery holder (as shown in the picture
below).
"Battery Safety"
starting on page 15. Datalogic recommends
Screw
Pass-through
Gryphon™ I GD4100/GM4100/GBT 4100/L GD4300
Screw
Screw
hole