References
Intercharacter Delay
This parameter specifies the intercharacter delay between the end of one character and the
beginning of the next. The delay can be set within a range of zero (0) to 990 milliseconds in
10ms increments. A setting of zero specifies no delay.
To set the delay:
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the result with lead-
3. Go to
4. Scan the barcode: SELECT INTERCHARACTER DELAY SETTING.
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See Table
Table 36. Intercharacter Delay Setting Examples
STEP
ACTION
1
Desired Setting
Divide by 10 (and pad with
2
leading zeroes to yield two-
digits)
3
4
Scan Two Characters From
5
Appendix D Keypad
6
294
This feature applies ONLY to the Keyboard Wedge interface.
ing zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
page 62
and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter
Programming Mode.
the duration which was determined in the steps above. You will hear a two-beep indica-
tion after the last character.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the begin-
ning.
Mode.
50ms
05
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT INTERCHARACTER DELAY SETTING
'0' and '5'
Scan ENTER/EXIT PROGRAMMING MODE
Appendix D
28
for some examples of how to set this feature.
EXAMPLES
150ms
600ms
15
'1' and '5'
'6' and '0'
Gryphon™ I GD4100/GM4100/GBT4100/L GD4300
Keypad, that represent
850ms
60
85
'8' and '5'