Rs-232/Usb Com Parameters - Datalogic Gryphon I GD4100 Product Reference Manual

References
•
•
RTS/CTS Scan Control — RTS is asserted during transmissions. CTS gates transmissions and
controls enable and disable state of scanner.

RS-232/USB COM Parameters

Intercharacter Delay
This parameter specifies the intercharacter delay between the end of one character and the
beginning of the next. The delay can be set within a range of zero (0) to 990 milliseconds in
10ms increments. A setting of zero specifies no delay.
To set the delay:
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the result with lead-
3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming
4. Go to
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit.
This completes the procedure. See
Table 28. Intercharacter Delay Setting Examples
STEP ACTION
1 Desired Setting
Divide by 10 (pad with leading
2
zeroes to yield two-digits)
3
4
Scan Two Characters From
5
Appendix D Keypad
6
286
RTS/XON/XOFF — RTS is asserted during transmissions. CTS is ignored. XON and
XOFF gate transmissions.
RTS On/CTS — RTS is always asserted. CTS gates transmissions.
ing zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
Mode.
page 47 and scan the barcode: SELECT INTERCHARACTER DELAY SET-
TING.
the duration which was determined in the steps above. You will hear a two-beep indica-
tion after the last character.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
50ms
05
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT INTERCHARACTER DELAY SETTING
'0' and '5'
Scan ENTER/EXIT PROGRAMMING MODE
Appendix D
Table 28 for some examples of how to set this feature.
EXAMPLES
150ms
15
'5' and '0'
Gryphon™ I GD4100/GM4100/GBT4100/L GD4300
Keypad, that represent
600ms 850ms
60 85
'6' and '0' '8' and '5'