Stand Mode Sensitivity; Scanning Active Time - Datalogic Gryphon I GD4100 Product Reference Manual
Gryphon series general purpose handheld linear imager or laser barcode readers
Hide thumbs
Also See for Gryphon I GD4100:
- Reference manual (428 pages) ,
- Product reference manual (370 pages) ,
- Quick reference manual (40 pages)
Table of Contents
Advertisement
Reading Parameters
Stand Mode Sensitivity
Sets the sensitivity level for stand mode wakeup. Choices are low, medium and high.
Stand Mode Sensitivity = Medium
Scanning Active Time
This setting specifies the amount of time that the reader stays in scan ON state once the state is
entered. The range for this setting is from 1 to 255 seconds in 1-second increments. See
page 309
Select Scanning Active Time Setting
Make a mistake? Scan the CANCEL barcode to abort and not
save the entry string. You can then start again at the begin-
ning.
DEFAULT
104
This feature is not applicable to the Gryphon L.
in "References" for descriptions of each feature
005 = Scanning is active for 5 Seconds
ENTER/EXIT PROGRAMMING MODE
Stand Mode Sensitivity = Low
DEFAULT
Stand Mode Sensitivity = High
CANCEL
Gryphon™ I GD4100/GM4100/GBT 4100/L GD4300
Advertisement
Table of Contents
