ENTER/EXIT PROGRAMMING MODE
These features allow configuration of source radio data inclusion.
Source Radio Address Transmission
Enables/disables the ability of source radio address information to be transmitted to the host
and, if so, at what position with respect to the label data. See
detailed information and examples for setting this feature.
DEFAULT
Source Radio Address Transmission = Prefix
Source Radio Address Delimiter Character
This option specifies the delimiter character to be placed between the label data and radio
address when address stamping is enabled.
Set Source Radio Address Delimiter Character
Make a mistake? Scan the CANCEL barcode to abort and not
save the entry string. You can then start again at the begin-
ning.
DEFAULT
Product Reference Guide
RF ADDRESS STAMPING
When included as a prefix, the source-radio ID is displayed after all label
formatting has been applied. The 6 byte hex address is sent as 12 ascii char-
acters, i.e., an address of 00 06 66 00 1A ED will be sent as (shown in hex):
30 30 30 36 36 36 30 30 31 41 45 44
This feature only applies if "Source Radio Address Transmission"on
269
page
is enabled.
00 = No Delimiter Character
Source Radio Address Transmission
page 312
Source Radio Address Transmission = Do Not Include
CANCEL
in "References" for
269