Data Format
Global Prefix/Suffix
This option sets up to 20 characters each from the set of ASCII characters or any hex value from
00 to FF. The characters may be added as a prefix (in a position before the barcode data, also
called a header) and/or as a suffix (in a position following the barcode data, also called a footer).
See
page 299
To configure this feature, scan the ENTER/EXIT PROGRAMMING MODE barcode above
to place the unit in Programming Mode, then the "Set Global Prefix" or "Set Global Suffix,"
barcode followed by the digits (in hex) from the Alphanumeric characters in
representing your desired character(s). If less than the expected string of 20 characters are
selected, scan the ENTER/EXIT barcode to terminate the string. Exit programming mode by
scanning the ENTER/EXIT barcode again.
Set Global Suffix
Make a mistake? Scan the CANCEL barcode to abort and not
save the entry string. You can then start again at the beginning.
78
for more detailed instructions on setting this feature.
DEFAULT
Global Suffix = 0x0D (CR)
ENTER/EXIT PROGRAMMING MODE
Set Global Prefix
CANCEL
No Global Prefix
Gryphon™ I GD4100/GM4100/GBT 4100/L GD4300
Appendix D, Keypad