Remove The Material; Remove The Material From The Machine; Cut The Material From The Roll - Roland CammJet CJ-500 User Manual

Remove the Material

Remove the Material from the machine

1
Press the [SETUP] key. Hold down for about 1
second.
The SETUP LED goes out
3
Open the front cover.
To remove the material.

Cut the material from the roll

Either of two methods can be used to separate a portion that's already been cut or printed from the roll. One method is to press the
[SHEET CUT] key. The other method is to perform separation automatically by sending a material-cutting command from the computer.
When separating the material by pressing the [SHEET CUT] key
Holding down the [SHEET CUT] key for 1 second or longer
severs the material at the present location of the blade tip.
* This operation isn't necessary when
sending a material-cutting command
from the computer to separate the
material automatically.
2
The material is cut off here.
Cut or printed
portion
Remove the Material
Move the sheet loading lever toward the back of the
unit.
The pinch rollers rise to release the material.
Sheet loading lever
Present location of
the blade tip
39