Ending Printing Operations; Remove The Material; Separating The Printed Portion - Roland FJ-50 User Manual

2-7 Ending Printing Operations

Remove the Material

1
If you wish to cut off the piece of the rolled material
containing the printed area, press the [SHEET CUT]
key. Hold down for about 2 second.
The piece is cut off at the present location of the
printing-start line.
* This operation isn't
necessary when sending a
material-cutting command
from the computer to
separate the material
automatically.
3
Move the sheet loading lever toward the back of the
unit.
The pinch rollers rise to release the material.

Separating the Printed Portion

Either of two methods can be used to separate a portion that's already been printed from the roll. One method is to press the [SHEET
CUT] key. The other method is to perform separation automatically by sending a material-cutting command from the computer.
When separating the material by pressing the [SHEET CUT] key
Holding down the [SHEET CUT] key for 2 seconds or longer severs the material at the present position of the printing-start line.
Printed portion
Sheet loading lever
The material is cut off here.
2
Press the [SETUP] key. Hold down for about 1
second.
The SETUP LED goes out
4
Open the front cover.
To remove the material, follow the steps for loading it
in reverse.
Knife guide
Printing-start line
2 Basic Operation
31