Setup For Printing And Cutting - Roland CammJet CJ-500 User Manual

Setup for Printing and Cutting

Setup for Printing and Cutting
Before performing printing and cutting, set up the machine as follows.
1 Loading the Material
Refer to "Setup for Printing -- 1 Loading the Material" and load the material correctly.
2 Installing a Blade
Refer to "Setup for Cutting -- 2 Installing the Blade" and install the blade correctly.
3 Test Printing
Refer to "Setup for Printing -- 2 Printing Test" and check the state of the heads.
4 Setting the Printing Mode and Printing Direction
Refer to "Setup for Printing -- 3 Selecting the Printing Mode and Direction of Printing" and make the settings for the modes.
5 Test Cutting
Refer to "Setup for Cutting -- 3 Cutting Test" and perform a cutting test and adjust the cutting conditions.
36