Remove the Material
Remove the Material
Remove the Material From the Machine
1
If you wish to cut off the piece of the rolled material
containing the printed area, press the [SHEET CUT]
key. Hold down for about 1 second or longer.
The piece is cut off at the present location of the
printing-start line.
* This operation isn't
necessary when sending a
material-cutting command
from the computer to
separate the material
automatically.
3
Move the sheet loading lever toward the back of the
unit.
The pinch rollers rise to release the material.
Cut the Material From the Roll
Either of two methods can be used to separate a portion that's already been cut or printed from the roll. One method is to press the
[SHEET CUT] key. The other method is to perform separation automatically by sending a material-cutting command from the computer.
When separating the material by pressing the [SHEET CUT] key
Holding down the [SHEET CUT] key for 1 second or longer
severs the material at the present location of the blade tip.
* This operation isn't necessary when
sending a material-cutting command
from the computer to separate the
material automatically.
36
Sheet loading lever
Printed portion
2
Press the [SETUP] key. Hold down for about 1
second or longer.
The SETUP LED goes out
4
Open the front cover to remove the material.
The material is cut off here.
Present location of
the blade tip
Printing-start line