Turn ON the main power first Then turn ON secondary power. The main display will prompt you to select an ink type and press ENTER. Roland CJ-500 Or Roland Hi-Fi JET Ver.1.00 No ink is filled. Roland CJ-500 UNKNOWN INK TYPE...
Setup for Printing Loading Flat Material Pass the material between the pinch rollers and the grit Refer to steps 5 and 6 in "Loading Roll Material," and rollers as shown in the figure. position the material and the pinch rollers correctly. Move the sheet loading lever toward LOAD.
Head test print Before starting to print, perform the Head Test Print to check the state of the head. Missing dots may reduce the printing quality. On the CAMMJET simply press [Print Test]. On the FJ: If there are any missing dots or other evidence of a drop in printing quality, clean the head (see User’s Manual section concerning "Cleaning the Printing Heads").
CAMMJET/Hi-Fi JET Print Quality There are 14 print modes on the CAMMJET and 12 on the Hi-Fi JET. The informatoin below explains the modes - each is available in uni-directional and bi-directional print modes. Printing Mode Printing Direction PHOTO: This is suitable for printing photographs. UNI-DIRECTION: Uni-directional printing.
Performing a Test Cut [CAMMJET ONLY] ] , [ ] , [ ] and [ ] keys to move Install a blade and load a material, then close the front Use the [ cover. the tool carriage to the place where the test cutting is to be performed.