Making Corrections For Printing - Roland CammJet CJ-500 User Manual

User's Reference

Making Corrections for Printing

Feed Correction
This corrects for errors in the amount of feed of the grit rollers due the type of material.
Be sure to make this setting when you have replaced the material with a different type.
Correcting the amount of feed improves the dot-positioning accuracy in the feed direction, which can help enhance image quality.
- When performing test printing for feed correction, load the material correctly (see "Setup for Printing -- Loading
the Material"). If the material is not loaded correctly, an accurate test pattern may not be output.
- When you use the program to set a correction value for the amount of feed, the program's setting takes priority.
The setting made with the control panel for the CJ-500/400 takes effect only in cases where the program does not
perform correction of the amount of feed.
1
Press the [MENU] key and [
following screen appear on the display.
3
Press the [ ] key to make the
following screen appear on the display.
PRINTING ADJ.
TEST PRINT
5
Check the test pattern and choose a
value with no displacement.
6
Press the [ ] key to make the following screen
appear on the display.
PRINTING ADJ.
ADJUST
7
Press the [ ] key to make the following screen
appear on the display.
ADJUST
-0.10% -0.10%
62
] key to make the
MENU
CALIBRATION
* Printing a Pattern
in Steps of 0.10%
2
Press the [ ] key to make the following screen
appear on the display.
CALIBRATION
PRINTING ADJ.
4
Press the [ENTER] key to start printing a test pattern.
Test pattern
8
Use the [ ] and [
checked in step 4, then press the [ENTER] key.
ADJUST
-0.10% +0.20%
-2.0% to +2.0%
(In steps of 0.05%)
* Test printing prints the pattern in steps of 0.10%.
+0.30%
+0.25%
Value with no
+0.20%
displacement
+0.15%
+0.10%
+0.05%
0.00%
-0.05%
-0.10%
Current
setting
-0.15%
] keys to set the value you