2-6 Ending Printing Operations
Remove the Material
If you wish to cut off the piece of the rolled material
1
containing the printed area, press the [SHEET CUT]
key. Hold down for about 1 second.
The piece is cut off at the present location of the
printing-start line.
* This operation isn't necessary when sending a
material-cutting command from the computer to
separate the material automatically.
When the SETUP LED is lighted, hold down the
2
[SETUP] key for at least one second.
Move the sheet loading lever toward the back of the
3
unit.
The pinch rollers rise to release the material.
Open the front cover.
4
To remove the material, follow the steps for loading it
in reverse.
Separating the Printed Portion
Either of two methods can be used to separate a portion that's already been printed from the roll. One method is to press the [SHEET
CUT] key. The other method is to perform separation automatically by sending a material-cutting command from the computer.
When separating the material by pressing the [SHEET CUT] key
Holding down the [SHEET CUT] key for 1 seconds or longer severs the material at the present position of the printing-start line.
Printed portion
The SETUP LED goes out
Sheet loading lever
The material is cut off here.
Knife guide
Printing-start line
2 Basic Operation
37