Remove The Printed Material, Then Reload The Material And Perform Cutting - Roland CAMM JET CJ-70 User Manual

Remove the Printed Material, then Reload the Material and Perform Cutting

1
Press the
the following screen appear on the display.
2
Press the
screen appear on the display.
3
Use the key to select "PRINT," then
press the
CROP MARK
DISABLE PRINT
6
Install the alignment tool on the cutting carriage.
7
1) Set the base point
Use the arrow keys to move
the tip of the alignment tool
to the square crop mark at
the lower right area of the
material, then press the
key.
• The align point cannot be set to both the lower left and upper right points.
• The align point cannot be set if the angle between the base point and the align point is 5 degrees or more.
• Marks set with the application software (such as crop marks) cannot be used.
8
Remove the alignment tool from the cutting
carriage and install the blade holder.
key and key to make
MENU
CROP MARK
key to make the following
CROP MARK
DISABLE DISABLE
key.
4
Send the printing data from the computer.
Three crop marks are automatically printed on the
left and right areas at the front edge of the
material.
5
When printing is finished press the
remove the material and carry out lamination (or
whatever further processing needs to be done).
When done, reload the material in the same
position used for printing, and press the
key. (The SETUP LED lights up.)
Rear
2) Set the align point
Front
9
Send the cutting data from the computer.
Rear
Front
Crop marks
key,
Use the arrow keys to move
the tip of the alignment tool
to the square crop mark at
the lower left area or upper
right area of the material,
then press the key.
25