Description Of Menu Items; Description Of Menus - Roland CammJet CJ-500 User Manual

Description of Menu Items

Description of Menus

Pressing the [MENU] key enters the menu mode.
Top
Submenu
menu
DEMO PRINT &
CUT
CARIBRATION PRINTING
ADJ.
(*)
CUTTING
ADJ.
BIDIRECTION
TEST PRINT
ADJUST
—
OVER
PRINT
(*)
—
DRYING
TIME
(*)
—
EDGE
SENSE
—
CROP MARK
(*)
This performs printing or cutting of sample data.
[PRINT & CUT]: This outputs the sample data for printing and cutting.
[PRINT]: This outputs the sample data for printing.
[CUT]: This outputs the sample data for cutting.
This corrects for errors in the amount of feed of the grit rollers due the
type of material.
Be sure to make this setting when you have replaced the material with
a different type.
Make this setting again when horizontal stripes are plainly visible on
printing results.
[TEST PRINT]: This menu is for verifying the adjustment.
[ADJUST]: This sets the correction value.
For more information, see "User's Reference -- Making Corrections for
Printing -- Feed Correction"
This corrects the cutting length relative to the print length (distance
correction).
For more information, see "User's Reference -- Aligning the Printing
Length and Cutting Length"
[FEED ADJUST]: This sets the adjustment value for the material-feed
direction.
[SCAN ADJUST]: This sets the adjustment value for the left-right
direction (the carriage-movement direction).
This adjusts for slippage when performing bidirectional printing.
This must be readjusted when you have replaced the material with a
different type or adjusted the head height.
[TEST PRINT]: This menu is for verifying the adjustment.
[ADJUST]: This sets the correction value.
For more information, see "User's Reference -- Making Corrections for
Printing -- Bidirectional Correction."
You can carry out the same printing superimposed over the same
location. When printing materials such as fabric, colors may not come
out well with just a single printing pass.
This should normally be set to [NONE].
For more information, see "User's Reference -- Performing Overprint-
ing."
This sets the drying time for the material. For materials with low
absorbency that are difficult to dry, make the setting for a longer time.
When printing is followed by cutting, cutting is performed after
waiting for the set time.
This specifies whether detection of the front and rear edges of the
material is enabled or disabled.
This should normally be set to [ENABLE].
When loading transparent material or material with a width of 90 to 430
mm (3.5 to 17 in.), set this to [DISABLE]. When set to [DISABLE],
then during material setup only the [ROLL] selection is available. When
doing this, ensure a margin of 35 mm (1-7/16 in.) or more from the
leading edge of the material to the start position for printing or cutting.
This specifies whether output of crop marks is enabled or disabled.
When set to [ENABLE], crop marks are automatically added to the
data sent from the computer and printed.
(*) When you use the program to make the setting for the
corresponding item, the program's setting takes priority.
To give priority to the setting made on the CJ-500/400,
turn off the program's settings.
Function
Description of Menu Items
Setting Default
range value
— —
[PRINTING ADJ.]
0%
-2.0% to +2.0%
(In steps of 0.05%)
[CUTTING ADJ.]
0%
-2.0% to +2.0%
(In steps of 0.01%)
-15 to +15 Correction
(In steps of 1)
value when
shipped
from the
factory
NONE/2/3 NONE
NONE/ NONE
10 to 990 sec.
(In steps of 10 sec.)
ENABLE/ ENABLE
DISABLE
ENABLE/ DISABLE
DISABLE
77