Setting The Page Margins - Roland CammJet CJ-500 User Manual

User's Reference

Setting the Page Margins

This makes the setting for the margin between pages.
When outputting a number of pages continuously, you can establish a margin between the pages.
You can set this in a range of 0 mm to 100 mm (in 10 mm steps).
This is set at 20 mm when shipped from the factory.
Start of the next output
End of output
Margin (value set for [PAGE MARGIN])
[When the material is not cut off]
1
Press the [MENU] key and [
following screen appear on the display.
3
Use the [ ] and [
the [ENTER] key.
PAGE MARGIN
20mm 10mm
0 to 100 mm
(In steps of 10 mm)
- When separating the material with the margin set at [0], the position where the material is separated and the end of
printing/cutting may not match.
- When performing continuous printing with the margin set at [0], image quality just after starting to print may be
poor on the second page or after. Also, dot drop-out or overlap may occur at the page borders.
- When you use the program to set the page margins, the program's settings take priority.
The setting made with the control panel for the CJ-500/400 takes effect only in cases where the settings for page
margins are not made with the program.
66
35 mm (1-1/8 in.)
] key to make the
MENU
PAGE MARGIN
] keys to set a margin, then press
Start of the next output
End of output
Location where separated
Margin (value set for [PAGE MARGIN])
[When the material-cutting command is enabled]
2
Press the [ ] key to make the following screen
appear on the display.
PAGE MARGIN
20mm
35 mm
(1-1/8 in.)
35 mm (1-1/8 in.)
20mm