Roland CammJet CJ-500 User Manual page 34

Setup for Cutting
Loading Flat Material
1
Pass the material between the pinch rollers and the grit
rollers as shown in the figure.
Pass the material
3
Move the sheet loading lever toward LOAD.
The pinch rollers lower to hold the material in place.
Sheet loading lever
When moved partway,
only the right-hand pinch
roller descends.
Data cannot be output
while in this state. To
secure the material in
place, move all the way
to "LOAD."
5
Press the [SETUP] key. This detects the width and
length of the material and shows the printable width
and length on the display.
The SETUP LED lights up
*If the material is misaligned and looks like it might
come loose from the pinch rollers, or actually does
come loose, please reload the material.
- When loading flat material, if the material touches the shaft or roll material at the back of the machine, remove the
shaft and roll material.
- If the sides of the material have warped, then bend back the warp or feed the warped portion to the front and
perform setup again.
32
Top menu
W1000mm L1230mm
FINE BI-DIR
2
Refer to steps 5 and 6 in "Loading Roll Material," and
position the material and the pinch rollers correctly.
4
Close the front cover.
Use the [ ] and [
press the [ENTER] key.
SETUP SHEET
ROLL EDGE PIECE
If [PIECE] does not appear, set [EDGE SENSE]
to [ENABLE].
If a pinch roller is positioned over an area where is no
grit roller, the massage shown at below appears when
you press the [SETUP] key.
PINCHROLL ERROR
INVALID LEFTPOS
] keys to select [PIECE], then
or [RIGHT]