Are The Pinch Rollers Placed On The Proper Locations; Have You Corrected The Misalignment Of Printing And Cutting; Is The Blade Holder Installed Appropriately; Is The Blade Worn - Roland TrueVIS SG3-540 User Manual

Are the pinch rollers placed on the proper locations?

Be sure to place the pinch rollers on the grit rollers. If the pinch rollers are not placed on the proper loca-
tions, misalignment of the media may occur.
RELATED LINKS
・ P. 30 Setup of New Media
・ P. 67 Setup of Registered Media

Have you corrected the misalignment of printing and cutting?

Misalignment between the printing and cutting positions may occur due to the thickness of the media or
the head height. Make corrections for misaligned printing and cutting for the media you are using.
RELATED LINKS
・ P. 182 Accurately Adjusting the Settings for Printing and Cutting

Is the blade holder installed appropriately?

When installing the blade holder, firmly tighten the screw and check that the blade holder is fixed in
place.
RELATED LINKS
・ P. 263 Replacing the Blade

Is the blade worn?

A worn or chipped blade will negatively affect the cutting quality. Check the status of the blade and re-
place it with a new one if necessary.
RELATED LINKS
・ P. 263 Replacing the Blade

Is there any buildup of pieces of material or dust inside the blade holder?

Remove the blade holder, and then take off the tip of the blade holder and remove any pieces of material
or dust inside.
After cleaning, adjust the amount of blade extension.
RELATED LINKS
Cutting Is Misaligned, Skewed, or Not Clean
Output Quality Problems
281