Gas Dryers; Display Fault Codes - Maytag Bravos MED6300TQ Technical Education

Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.

DISPLAY FAULT CODES

The fault codes below would be indicated
when attempting to start a drying cycle or af-
ter activating the diagnostic test mode.
DISPLAY DESCRIPTION EXPLANATION / RECOMMENDED PROCEDURE
PF flashes to indicate that a power failure
Power occurred while the dryer was running. Press
PF
Failure
START to continue the cycle, or press
PAUSE/CANCEL to clear the display.
F-01 flashes when there is a primary control
Primary
failure. Replace the machine control electronics.
F-01
Control
See Accessing & Removing the Electronic
Failure
Assemblies.

Gas Dryers

See Accessing & Removing the
Electronic Assemblies, to access:
Machine Control Electronics
User Interface Assembly
Door
Switch
Figure 1. Component locations.
WARNING
Electrical Shock Hazard
DISPLAY DESCRIPTION
Keypad/
F-02
User Interface
Failure
Exhaust
F-22
Thermistor
Open
Exhaust
F-23
Thermistor
Shorted
Motor Drive
F-26
System Failure
Moisture
F-28
Sensor Open
Moisture
F-29
Sensor
Shorted
See Removing the Back Panel,
to access:
High-Limit Thermostat
Thermal Cut-off
Drum Light Assembly
Moisture Sensor
(Behind Strips)
Thermal Fuse
Exhaust Thermistor
See Removing the
Front Panel/Drum A ssembly,
to access:
Drive Motor
Belt Switch
Heater Assembly
6-16
EXPLANATION / RECOMMENDED PROCEDURE
F-02 flashes when there is a stuck button or user
interface mismatch. This fault code will ONLY
appear when in the diagnostic test mode. See
TEST #6.
F-22 flashes if the exhaust thermistor is open.
See TEST #4a.
F-23 flashes if the exhaust thermistor has
shorted. See TEST #4a.
F-26 flashes if there is a motor drive system
failure. See TEST #3.
F-28 flashes if the moisture sensor strip is open.
This fault code will ONLY appear when in the
diagnostic test mode. See TEST #5.
F-29 flashes if the moisture sensor strip has
shorted. This fault code will ONLY appear when in
the diagnostic test mode. See TEST #5.