Maytag Bravos MED6300TQ Technical Education page 103

1. Unplug dryer or disconnect power.
2. Remove two screws from the rear of the
console assembly. Pull console towards
front of dryer to hinge open and/or re-
move console.
REMOVING THE MACHINE
CONTROL ELECTRONICS
3. Remove the wire connections to the
machine control assembly.
4. Remove the one screw holding the
machine control assembly to the met-
al bracket. See Figure 15.
5. Push in on the tab located on the back
of the machine control to slide it off the
bracket.
REMOVING THE USER
INTERFACE ASSEMBLY
3. Remove the wire connections from the
user interface assembly, including the
P5 ribbon cable. See Figure 15.
4. Remove the cycle selector knob from
the front of the console by firmly pull-
ing on it or carefully prying straight up-
ward.
5. The user interface assembly is held
to the console insert panel by three
screws and two locking tabs. After the
screws are removed, lift each of the
locking tabs to remove the back cover
of the user interface assembly. See
Figure 15.
6. Remove the cycle selector switch from
the user interface assembly opening
by lifting the locking tab on the cycle
selector switch and turning the selec-
tor switch in a counterclockwise direc-
tion. See Figure 17.
7. Locking tabs located at the bottom of
the console insert panel secure the
user interface assembly to the con-
sole insert panel. Using a flat-blade
screwdriver, gently apply pressure to
the locking tabs to release the user in-
terface assembly. See Figure 17.
Figure 17. Gently apply pressure to locking tabs to
release the user interface assembly.
REINSTALLING THE
ELECTRONIC ASSEMBLIES
Refer to preceding removal sections and re-
place in reverse order.
NOTE: When replacing the cycle selector
switch, make sure that the shaft is positioned
through the center of the shaft seal that is
captive between the decorative overlay and
the console insert panel.
NOTE: When reconnecting wire connections,
be sure to route the user interface wires be-
neath the retainer clips on the user interface
back cover.
6-29
Cycle Selector
Switch
Locking
Tabs
User Interface
Assembly