End Of Cycle Signal; Drying Rack Option - Maytag Bravos MED6300TQ Technical Education

NOTE: The Damp Dry Chime is available only
with the Sensor Dry Cycles.

END OF CYCLE SIGNAL

END OF CYCLE SIGNAL
The End of Cycle Signal produces an au-
dible sound when the drying cycle is finished.
Promptly removing clothes at the end of the
cycle reduces wrinkling.
Press END OF CYCLE SIGNAL until the desired
volume (High, Low or Off) is selected.
NOTE: When Wrinkle Prevent
lected, and the End of Cycle Signal is on, a tone
sounds every 5 minutes until the clothes are
removed, or Wrinkle Prevent
CHANGING CYCLES, MODIFIERS
AND OPTIONS
You can change Sensor Dry and Timed Cycles,
Modifiers and Options anytime before press-
ing Start.
• Three short tones sound if an unavailable
combination is selected. The last selection
will not be accepted.
CHANGING CYCLES AFTER
PRESSING START
1. Press PAUSE/CANCEL twice.
2. Select the desired cycle and options.
3. Press START. The dryer starts at the begin-
ning of the new cycle.
NOTE: If you do not press Start within 5 min-
utes of selecting the cycle, the dryer automati-
cally shuts off.
CHANGING MODIFIERS AND
OPTIONS AFTER PRESSING START
You can change a Modifier or Option anytime be-
fore the selected Modifier or Option begins.
1. Press PAUSE/CANCEL once.
setting is se-
™
setting ends.
™
3-7
2. Select the new Modifier and/or Options.
3. Press START to continue the cycle.
NOTE: If you happen to press PAUSE/CAN-
CEL twice, the program clears and your dryer
shuts down. Restart the selection process.
CHANGING THE PRESET DRYNESS
LEVEL SETTINGS
If all of your loads on all Sensor Dry cycles are
consistently not as dry as you would like, you
may change the preset Dryness Level settings
to increase the dryness. This change will affect
all of your Sensor Dry cycles.
Your Dryness Level settings can be adjusted to
adapt to different installations, environmental
conditions or personal preference. There are 3
drying settings: 1 (factory preset dryness level),
2 (slightly dryer clothes, approximately 15%
more drying time) and 3 (much dryer clothes,
approximately 30% more drying time).
1. The Dryness Level settings cannot be
changed while the dryer is running.
2. Press and hold the DRYNESS button for 5
seconds. The dryer will beep, and "CF" will
be displayed for 1 second followed by the
current drying setting.
3. To select a new drying setting, press the
DRYNESS button again until the desired
drying setting is shown.
NOTE: While cycling through the settings,
the current setting will not flash, but the
other settings will flash.
4. Press START to save the drying setting.
5. The drying setting you selected will become
your new preset drying setting for all Sensor
Dry cycles.

DRYING RACK OPTION

Use the Drying Rack to dry items such as
sweaters and pillows without tumbling. The
drum turns, but the rack does not move.
If your model does not have a drying rack, you
may be able to purchase one for your model. To
find out whether your model allows drying rack
usage and for ordering information, contact the
dealer from whom you purchased your dryer.