Adjusting Customer-Focused Drying Modes - Maytag Bravos MED6300TQ Technical Education

No beep sound is heard:
1. Perform steps in Accessing & Removing
the Electronic Assemblies, and visually
check that the P5 connector is inserted
all the way into the machine control elec-
tronics.
• If visual check passes, replace the user
interface assembly.
2. Plug in dryer or reconnect power.
3. Perform the Console Buttons and Indica-
tors Diagnostic test to verify repair.
4. If replacing the user interface assembly
failed:
• Unplug dryer or disconnect power.
• Replace the machine control electronics.
• Plug in dryer or reconnect power.
• Perform the Console Buttons and Indi-
cators Diagnostic test to verify repair.
Some buttons do not light indicators:
1. Perform steps in Accessing & Removing
the Electronic Assemblies, and visually
check the user interface assembly con-
nections.
• If visual check passes, replace the user
interface assembly.
2. Plug in dryer or reconnect power.
3. Perform the Console Buttons and Indica-
tors Diagnostics test to verify repair.
TEST #7 Door Switch
Activate the diagnostic test mode and perform
the Door Switch Diagnostic test.
Functionality is verified with a beep each time
the door is closed and opened, and a num-
ber and letter appears in the display (i.e., 0E,
09).
If any of the above conditions are not met:
• Unplug dryer or disconnect power.
• Check that the wires between the door
switch and machine control electron-
ics are connected. See Figure 12 for
switch location, and see Removing the
Front Panel/Drum Assembly.
• If the connections are OK, replace the
door switch assembly and retest.
• If the door switch assembly has been re-
placed and dryer still does not start, re-
place the machine control electronics.
Figure 12. Door switch location.
ADJUSTING CUSTOMER-FOCUSED
DRYING MODES
NOTE: If the customer is complaining about
the clothes being damp and the moisture sen-
sor passes TEST #5, step 3, the total dry time
can be lengthened by changing from a "1"
(standard auto cycle) to a "2" (15% more dry-
ing time) or "3" (20% more drying time) auto
cycle.
1. Press and hold the Dryness button for
5 seconds. The dryer will beep and dis-
play CF for one second, then the current
drying mode will be seen on the display.
The factory default value is "1".
2. To select a different drying mode, press
the Dryness button again. The dryer dis-
play will flash and show the available set-
tings.
3. With the display flashing the selected
drying mode, press the Start button to
save the drying mode and exit (the Start
button in this mode does not start a dry-
ing cycle). The result will be stored in EE-
PROM of the control board, and will be
retained after a power loss.
4. Press the Pause/Cancel button at any
time to cancel changes and exit from this
mode.
6-27
Door Switch