Accessing & Removing The Electronic Assemblies - Maytag Bravos MED6300TQ Technical Education

5. Push on the retaining clips located under
top of dryer on the right and left side us-
ing a flat object such as a putty knife. See
Figure 12.
Front Cover Screw
(Inside Cabinet)
Top Clips
Figure 12.
Slowly rotate top backwards
and support.
6. Slowly rotate top backwards and lean
against wall, or support with a prop rod.
7. Disconnect the door switch wire harness
located on the right side. See Figure 12.
8. Remove the front panel/door assembly
by removing the two front cover screws
at the top of the panel inside the cabinet,
and lifting upward.
9. Remove the front bulkhead by loosening
the upper two screws and removing the
lower two screws. See Figure 13.
Drum Face
Plate
Figure 13.
Door Switch
Wire Harness
Connector
Lint Screen
Duct
Remove the front bulkhead.
10. Lower components can be accessed at
this time, however, if the drum is to be
removed, the belt must be removed. See
TEST #3, step 5.
REINSTALLING THE FRONT PANEL/
DRUM ASSEMBLY
Refer to preceding removal sections and re-
place in reverse order.
ACCESSING & REMOVING THE
ELECTRONIC ASSEMBLIES
There are two electronic assemblies; the user
interface electronics, and the machine control
electronics. See Figures 14 and 15.
3 Screws
P5
Ribbon
Cable
User Interface
Assembly Back Cover
Figure 14.
1. Unplug dryer or disconnect power.
2. Remove two screws from the rear of the
console assembly. Pull console towards
front of dryer to hinge open and/or re-
move console.
REMOVING THE MACHINE
CONTROL ELECTRONICS
3. Remove the wire connections to the
machine control assembly.
4. Remove the one screw holding the
machine control assembly to the met-
al bracket. See Figure 14.
5. Push in on the tab located on the back
of the machine control to slide it off the
bracket.
6-14
Back Cover Locking Tabs
Screw
Metal Bracket
Machine Control
Electronics
Assembly
Locate the electronic assemblies.