Maytag Bravos MED6300TQ Technical Education page 64

Support Bracket Screw
d) Remove the two 5/16˝ hex-head screws
from the burner bracket.
e) Pull the burner assembly forward, un-
hook the bracket tabs from the chas-
sis slots, and remove the assembly.
Burner Bracket Screws
Ignitor
Burner Assembly
Flame Sensor
Connector
Burner Harness
Connector
Coils
7. To remove the coils from the burner
assembly:
a) Remove the burner assembly (see step
6).
b) Disconnect the 2-wire and 3-wire con-
nectors from the coil pins.
c) Remove the two screws from the brack-
et, and lift the two coils off their cores.
8. To remove the ignitor from the burner
assembly:
a) Remove the burner assembly (see step
6).
b) Disconnect the 2-wire connector from
the ignitor harness.
c) Loosen the 5/16˝ hex-head ignitor
screw, and remove the ignitor from the
bracket.
Ignitor Screw
4-16
Coil Connectors
Coil Assembly
2 Coils
Bracket
Connector