DIAGNOSTIC: Door Switch
Opening the door should cause a beep and
an alphanumeric number to be displayed.
Closing the door should cause a beep and 88
to be displayed.
•
If opening the door fails to cause a beep
and a number and letter to be displayed,
go to TEST #7.
DIAGNOSTIC: Moisture Sensor
Open the door and locate two metal strips on
the inside of the dryer. Bridge these strips with
a wet cloth or a finger.
•
If a continuous beep tone is heard and an
alphanumeric number is displayed on the
console, the sensor is OK.
•
If not, or if a continuous beep tone is heard
before bridging the moisture strips, go to
TEST #5.
Figure 2.
DIAGNOSTIC: Motor, Heater,
And Console ID
Close the door. Press the Start button. The
motor and heater will turn on, and the display
will show console ID69.
•
If the Console ID above is not displayed,
replace the user interface assembly. See
Accessing & Removing the Electronic As-
semblies.
•
If the motor does not turn on, go to TEST #3.
•
If no heat is detected, go to TEST #4.
6-3
Console Diagnostics.