Removing The Front Panel/Drum Assembly; Accessing & Removing The Electronic Assemblies - Maytag Bravos MED6300TQ Technical Education

REMOVING THE FRONT
PANEL/DRUM ASSEMBLY
1. Unplug dryer or disconnect power.
2. Remove the lint screen.
3. Remove the two screws holding the lint
screen duct to the top.
4. Open the door.
5. Push on the retaining clips located under
top of dryer on the right and left side us-
ing a flat object such as a putty knife. See
Figure 13.
Front Cover Screw
(Inside Cabinet)
Top Clips
Figure 13. Slowly rotate top backwards and support.
6. Slowly rotate top backwards and lean
against wall, or support with a prop rod.
7. Disconnect the door switch wire harness
located on the right side. See Figure 13.
8. Remove the front panel/door assembly
by removing the two front cover screws
at the top of the panel inside the cabinet,
and lifting upward.
Drum Face
Plate
Figure 14. Remove the front bulkhead.
Door Switch
Wire Harness
Connector
N.O. Heater
Lint Screen
Black Relay 1
Duct
Figure 16.
9. Remove the front bulkhead by loosening
the upper two screws and removing the
lower two screws. See Figure 14.
10. Lower components can be accessed at
this time, however, if the drum is to be
removed, the belt must be removed. See
TEST #3, step 4.
REINSTALLING THE FRONT PANEL/
DRUM ASSEMBLY
Refer to preceding removal sections and re-
place in reverse order.
ACCESSING & REMOVING THE
ELECTRONIC ASSEMBLIES
There are two electronic assemblies; the user
interface electronics, and the machine control
electronics. See Figures 15 and 16.
3 Screws
User Interface
Assembly Back Cover
Figure 15.
COM Motor
Blue Black
Relay
Red
P9
1
5
Black-White
Tan
White
Green-Yellow
1
P8 Brown
Machine control electronics.
6-28
Back Cover Locking Tabs
P5
Ribbon
Screw
Cable
Metal Bracket
Machine Control
Electronics
Assembly
Locate the electronic assemblies.
Yellow-Red
Red-White
Open
1
1
P13
P3
P5
8
1
P2
3
P14
1
6
3
P4
1
1
Black
Red-White