INSTALLATION INFORMATION
TOOLS AND PARTS
Gather the required tools and parts before
starting installation. Read and follow the in-
structions provided with any tools listed here.
Electric Models
•
Flat-blade screwdriver
•
#2 Phillips screwdriver
•
Adjustable wrench that opens to 1˝
(2.5 cm) or hex-head socket wrench (for
adjusting dryer feet)
•
Wire stripper (for direct wire installations)
•
Tin snips (new vent installations)
•
Level
•
Vent clamps
•
Caulking gun and compound (for installing
new exhaust vent)
•
Tape measure
Gas Models
•
8˝ or 10˝ pipe wrench
•
8˝ or 10˝ adjustable wrench (for gas con-
nections)
•
Flat-blade screwdriver
•
Adjustable wrench that opens to 1˝
(2.54 cm) or hex-head socket wrench (for
adjusting dryer feet)
•
1/4˝ nut driver or socket wrench
•
Level
•
Vent clamps
•
Knife
•
Pipe-joint compound resistant to LP gas
•
Caulking gun and compound (for installing
new exhaust vent)
•
Pliers
•
Tape measure
INSTALLATION INSTRUCTIONS
Parts supplied:
Remove parts package from dryer drum.
Check that all parts were included.
Parts needed:
Check local codes and with gas supplier.
Check existing gas supply, electrical supply
and venting. Read "Electrical Requirements,"
"Gas Supply Requirements" and "Venting Re-
quirements" before purchasing parts.
Mobile home installations require special
parts (listed following) that may be ordered by
calling the dealer from whom you purchased
your dryer. For ordering information, please
refer to the "Assistance or Service" section of
the "Use & Care Guide." You may also con-
tact the dealer from whom you purchased
your dryer.
•
Mobile home installation kit. Ask for Part
Number 346764.
•
Metal exhaust system hardware.
2-1
4 leveling legs