Maytag Bravos MED6300TQ Technical Education page 58

c) Remove the front and rear clamps from
the drive motor and its mounting bracket.
To remove a clamp, press down on one
end, and unhook it from the bracket tab.
Press Down On
Drive Motor Clamp
6. To replace the blower wheel:
a) Remove the four screws from the air
duct at the rear of the unit and pull the
duct forward so that you can access
the blower wheel (see page 4-18 for the
procedure).
b) Spin the blower wheel clockwise and
remove it from the drive motor shaft.
Blower Wheel
Remove
REASSEMBLY NOTE 1: The front and rear
clamps are slightly different (see the top right il-
lustrations). Make sure that you use the correct
clamp when you reinstall the drive motor.
REASSEMBLY NOTE 2: When you reinstall the
drive motor, make sure that the rounded locator
tab is in the bracket slot, as shown below.
Bracket Tab
7. To remove the belt switch:
a) Disconnect the two blue wires from the
b) Remove the two screws from the switch,
4-10
Front Clamp Rear Clamp
Longer Leg
Locator Tab In Slot
belt switch terminals.
and remove the switch from the drive mo-
tor bracket.
Screws
Blue Wires
Belt Switch