Removing The Back Panel; Removing User Interface Assembly; Reinstalling Electronic Assemblies - Maytag Bravos MED6300TQ Technical Education

Electric & gas dryers

Table of Contents

REMOVING THE USER

INTERFACE ASSEMBLY

3. Remove the wire connections from the

user interface assembly, including the

P5 ribbon cable. See Figure 14.

4. Remove the cycle selector knob from

the front of the console by firmly pull-

ing on it or carefully prying straight up-

ward.

5. The user interface assembly is held

to the console insert panel by three

screws and two locking tabs. After the

screws are removed, lift each of the

locking tabs to remove the back cover

of the user interface assembly. See

Figure 14.

6. Remove the cycle selector switch from

the user interface assembly opening

by lifting the locking tab on the cycle

selector switch and turning the selec-

tor switch in a counterclockwise direc-

tion. See Figure 16.

7. Locking tabs located at the bottom of

the console insert panel secure the

user interface assembly to the con-

sole insert panel. Using a flat-blade

screwdriver, gently apply pressure to

the locking tabs to release the user in-

terface assembly. See Figure 16.

Cycle Selector

Switch

Locking

Tabs

Figure 16.

Gently apply pressure to

locking tabs to release the user interface

assembly.

Heater

N.O.

COM

Relay 1

Black

Red

User Interface

Assembly

N.O.

COM

Heater Relay 2

Black

Violet

(Dual Element Model Only)

6-15

REINSTALLING THE

ELECTRONIC ASSEMBLIES

Refer to preceding removal sections and re-

place in reverse order.

NOTE: When replacing the cycle selector

switch, make sure that the shaft is positioned

through the center of the shaft seal that is

captive between the decorative overlay and

the console insert panel.

NOTE: When reconnecting wire connections,

be sure to route the user interface wires be-

neath the retainer clips on the user interface

back cover.