Maytag Bravos MED6300TQ Technical Education page 42

NOTE: The rack must be removed for normal
tumbling. Do not use the Sensor Dry cycle with
the drying rack.
To use the drying rack:
1. Open dryer door.
A. Front edge
2. Place drying rack inside dryer drum, posi-
tioning the back wire on the ledge of the
inner dryer back panel. Push down on front
edge of drying rack to secure at the front of
the dryer.
B
A
A. Dryer rack front edge
B. Dryer back panel
3. Put the wet items on top of the rack. Leave
space between the items so air can reach
all the surfaces.
NOTE: Do not allow items to hang over the
edge of the rack.
4. Close the door.
5. Press the POWER button.
6. Select a timed drying cycle and temperature
(see the following chart). Items containing
foam, rubber or plastic must be dried on
a clothesline or by using the Air Fluff tem-
perature setting.
7. You must select a time by pressing TIMED
CYCLE ADJUST Up or Down. Reset time
as needed to complete drying. Refer to the
A
following table.
8. Press (and hold) START button (about 1
second).
This chart shows examples of items that can
be rack dried and the suggested cycle, tem-
perature setting and drying time. Actual drying
time will depend on the amount of moisture
items hold.
Rack Dry
Wool Sweaters
Block to shape and lay flat on
the rack.
Stuffed toys or pillows
Cotton or polyester fiber filled
Stuffed toys or pillows
Foam rubber filled
Sneakers or canvas shoes
*(Minutes) Reset time to complete drying, if needed.
3-8
Setting Temp. Time*
Timed Low 60
Dry
Timed Low 60
Dry
Timed Air Fluff 90
Dry (no heat)
Timed Air Fluff 90
Dry (no heat)